Sony NHS-3020 Installation Manual page 39

System Rack: Cable TV, Terrestrial TV Antenna Feed
Connect the main cable TV feed (or rooftop antenna feed for terrestrial broadcasting) to the "RF [From CATV]" input on the
back panel.
System Rack: Satellite TV Feed
Connect the feed from the dish antenna directly to the "SAT" input on the back panel
System Rack: Set/top Box Phone/Ethernet
1. Insert the Phone RJ-11 plug or the Ethernet RJ-45 plug into the Phone/Ethernet RJ-45 jack.
2. If necessary, terminate the Ethernet cable with a "category-rated" RJ-45 plug. Start by using a cable stripping tool to strip
off about two inches of the jacket insulation.
3. Untwist each conductor and spread the conductors out. Use the so-called "T568A" or "A" standard wiring configuration.
To do this, arrange the conductors in the following order from left to right, as seen from the cable side:
A. Pin 1: White/Green
B. Pin 2: Green
C. Pin 3: White/Orange
D. Pin 4: Blue
E. Pin 5: White/Blue
F. Pin 6: Orange
G. Pin 7: White/Brown
H. Pin 8: Brown
4. Pull each conductor taut, flat and straight.
5. Bring the conductors together and insert them into an empty RJ-45 plug until the jacket is firmly seated under the insulation
clamp. The conductors should extend out the front of the plug.
6. Insert the plug into an RJ-45 crimping tool until it snaps in place.
7. Crimp the plug through the entire ratchet cycle of the crimping tool.
System Rack: AC Power
Plug the power strip AC cord into the grounded duplex AC output that is dedicated for the System Rack.
System Rack: Programming the remote for the Set-Top Box
You should already have performed this step in the Programming phase that precedes Installation. Please refer to Programming
section of this manual for detailed instructions.
System Rack: Program AM/FM station presets
Consult the A/V receiver operating instructions to program the AM/FM preset stations requested by the owner.
Installation
Wht/Green Green Wht/Orange Blue Wht/Blue Orange Wht/Brown Brown
37