Sony NHS-3020 Installation Manual page 26

Programming
5. While the code ID number is displayed in the display window, press the corresponding button on the remote control of the component
while pointing it toward the learning IR window of the Multi-Room Distribution Unit. Make sure the distance between the remote control
and the IR window is within 4 inches (10 cm). When your entry is successful, "COMPLETED!" appears for a few seconds, then the
display window moves to the next remote code entry. If your entry is not successful, "LEARN FAILED!" appears for a few seconds, then
the failed code ID number appears.
TIPS:
• When you want to skip the code ID number, press the cursor .
• When you want to re-enter the code ID, press the cursor .
NOTES:
• When the remote code has been successfully learned, a "*" will appear next to the remote code name.
• You can enter up to 29 remote codes for each source component, and up to 50 remote codes for each common component into the
Multi-Room Distribution Unit.
• You must complete step 5 within one minute after the remote code name is displayed in the display window; otherwise, your entry
will not be learned and "LEARN FAILED!" appears.
6. Repeat step 5 to enter other remote codes.
7. Press ENTER when you have finished. "SETTING NOW..." appears for a few seconds. Then, the display window returns to the
NORMAL mode.
NOTES:
• Even if you quit the LEARN mode in the midst of making the settings, the remote codes that have already been learned will be stored.
• Some remote codes cannot be learned. In this case, "MEMORY FULL" appears, then the display window returns to the previous remote
code entry. The remote codes that have already been learned will be stored.
Programming the F1 and F2 keys
You can also program the F1 and F2 keys for set-top box functions using EXPAND CODE. You will follow a similar procedure as in
"Programming the CAV-M1000ES" above. However, in Step 2, instead of selecting "CODE LEARNING," you'll select "EXPAND CODE." In
Step 3, you'll again want to select SOURCE 5. When you get to the CODE ID in Step 4, "CODE ID #081
"CODE ID #082 " corresponds to the F2 key.
Testing Learned Remote Codes
You can check to see if the remote code of the source component has been successfully learned by the Multi Room Distribution Unit.
1. Press SOURCE SELECT +/– to select the source component that you want to check.
2. Press MODE repeatedly until "<<CHECK>>"appears in the display window, then press ENTER. "SET COMMAND" appears for a few
seconds, then some of the learned remote codes appear in the display window.
3. Press the cursor or cursor repeatedly to select the remote code that you want to check (ex. play, stop).
4. Press ENTER. The selected remote command will be performed.
24
" corresponds to the F1 key and