Gun Setup; Gun Setup Procedure - Graco Pro Xp 60 AA WB Instructions - Parts Manual

Gun Setup

Setup
Gun Gun Setup
Gun Setup Setup Procedure Procedure
Gun Gun Setup Procedure
To reduce the risk of fire and explosion, fluids used
must meet the following flammability requirements:
• FM, FM, FM, FMc FMc FMc Approved: Approved: Approved:
Material does not sustain burning in accordance
with the Standard Test Method for Sustained
Burning of Liquid Mixtures, ASTM D4206.
• CE CE- - - EN CE EN 50059 EN 50059 50059 Compliant: Compliant: Compliant:
Material is classified as non-ignitable as defined
by EN 50059: 2018.
For more information, see
Ignitability of Coating Materials, page
Contact with the charged components of the spray
gun will cause an electric shock. Do not touch
the gun nozzle or electrode or come within 4 in.
(102 mm) of the electrode during operation or
until performing the Fluid Voltage Discharge and
Grounding Procedure, page
Follow the Fluid Voltage Discharge and Grounding
Procedure, page 29 when you stop spraying and
whenever you are instructed to discharge the
voltage.
To reduce the risk of component rupture, which
can cause serious injury, do not exceed the
maximum working pressure of the lowest rated
system component. This equipment has a 100 psi
(0.7 MPa, 7 bar) maximum air working pressure
and a 3000 psi (21 MPa, 210 bar) maximum fluid
working pressure.
3A2497H
73.
29.
To reduce the risk of an injury, follow the
Pressure Relief Procedure, page 28
are instructed to relieve the pressure.
See the figure below to locate the electrostatic gun
controls.
Figure 15 Electrostatic Gun Controls
1. Turn OFF (O) the ES On-Off switch (J).
2. Shut off the air bleed valve to the gun.
Gun Setup
whenever you
23