Gun Setup; Gun Setup Procedure; Hvlp Gun Setup Procedure; Round Spray Gun Setup Procedure - Graco WB100 Instructions-Parts List Manual

Gun Setup

Gun Setup Setup
Gun Gun Setup
Gun Setup Setup Procedure Procedure
Gun Gun Setup Procedure
To reduce the risk of fire and explosion, fluids used
must meet the following flammability requirements:
FM, FMc FMc Approved: Approved:
• FM, FM, FMc Approved:
Material does not sustain burning in accordance
with the Standard Test Method for Sustained
Burning of Liquid Mixtures, ASTM D4206.
• CE CE CE- - - EN EN 50059 EN 50059 50059 Compliant: Compliant: Compliant:
Materials which cannot be ignited, in any mixture
with air, by an energy source of less than 500mJ.
Contact with the charged components of the spray
gun will cause an electric shock. Do not touch the
gun nozzle or electrode or come within 4 in. (102
mm) of the front of the gun during operation or
until performing the Fluid Voltage Discharge and
Grounding Procedure, page
Follow the Fluid Voltage Discharge and Grounding
Procedure, page 39 when you stop spraying and
whenever you are instructed to discharge the
voltage.
To reduce the risk of component rupture, which
can cause serious injury, do not exceed the
maximum working pressure of the lowest rated
system component. This equipment has a 100 psi
(0.7 MPa, 7 bar) maximum working air and fluid
pressure.
To reduce the risk of an injury, follow the
Pressure Relief Procedure, page 39
are instructed to relieve the pressure.
26
39.
whenever you
For additional steps to set up specialty guns,
see Soft Spray Gun Setup Procedure, page
Round Spray Gun Setup Procedure, page
HVLP Gun Setup Procedure, page
Abrasive Material Gun Setup Procedure, page
and Mold Release Gun Setup Procedure, page
See the figure below to locate the electrostatic gun
controls.
Figure 22 Electrostatic Gun Controls
1. The gun is shipped with the fluid nozzle and air
cap installed. Check that the retaining ring is
tight.
NOTE: NOTE: To select a different NOTE:
size fluid nozzle or air cap, see
Fluid Nozzle Selection Chart, page 93
Air Cap Selection Guide, page
To install the nozzle and air cap, see
Air Cap and Nozzle Replacement, page
2. Turn OFF (O) the ES On-Off switch (J).
3. Shut off the air bleed valve to the gun.
4. Check gun resistance. Follow the steps in
Test Gun Resistance, page
30,
33,
31,
35,
36.
and
96.
59.
47.
3A2496H