Replacement - Graco Pro Xp 60 AA WB Instructions - Parts Manual

Repair
Figure 43 Smart Module
Figure 44 Align Ribbon Cables
Air Air Swivel Air Swivel and Swivel and Exhaust and Exhaust Exhaust Valve

Replacement

Replacement Replacement
1. Follow the steps in
Prepare the Gun for Service, page
2. To replace the air exhaust valve:
a. Remove the clamp (36) and the exhaust tube
(35).
b. Unscrew the swivel (21) from the gun handle
(16). The swivel is a left-hand thread.
Loosen the strain relief nut and move the
bracket out of the way.
c. Pull the exhaust valve (8) from the handle
(16). Inspect the o-ring (8a) and replace if
necessary.
d. Install the o-ring (8a*) on the exhaust valve
(8). Lubricate the o-ring with a light coating
of non-silicone grease.
e. Install the exhaust valve (8) in the handle
(16).
f. Apply thread sealant to the top threads of the
swivel (21). Position the bracket and screw
the swivel into the gun handle (16). Torque
to 75–85 in-lb (8.4–9.6 N•m). Tighten the
strain relief nut.
g. Install the tube (36) and clamp (43).
54
3. To replace the air inlet swivel:
Valve Valve
Figure 45 Air Inlet Fitting and Air Exhaust Valve
44.
a. Unscrew the swivel (21) from the gun handle
(16). The swivel is a left-hand thread.
b. Apply thread sealant to the top threads of the
swivel. Screw the swivel into the gun handle.
Torque to 75–85 in-lb (8.4–9.6 N•m).
3A2497H