Test Ground Strip Resistance; Test Cylinder Resistance - Graco Pro Xp 60 AA WB Instructions - Parts Manual

Electrical Tests
Test Ground Ground Strip Strip Resistance
Test Test Ground Strip
Using an ohmmeter, measure the resistance between
the latch housing (206) and the ground lug (214).
The ground strip is grounded through the cart back
to the ground lug. Resistance must be less than 100
ohms. If greater than 100 ohms, replace the ground
strip (240).
Figure 21 Test Ground Strip Resistance
38
Resistance
Resistance
Test Cylinder Cylinder Resistance Resistance
Test Test Cylinder Resistance
Remove the enclosure door. Using an ohmmeter,
measure the resistance from the pump (209) to the
ground lug (214). Resistance must be less than
100 ohms. If greater than 100 ohms, replace the
grounding cylinder.
Figure 22 Test Cylinder Resistance
3A2497H