Reverb High Frequency Decay (Configs 1, 2, 5, 6, 7); Reverb Gate Status (Configs 1, 2, 5, 6, 7); Reverb Gate Hold Time (Configs 1, 2, 5, 6, 7) - Alesis GT Reference Manual

Reverb High Frequency Decay (configs 1, 2, 5, 6, 7)

The display shows:
Separating the decay times for the high and low frequencies changes the
timbral quality of the reverb over time. The value is always a negative
number since this parameter shortens the time of reverb with high
frequency content compared to the master reverb decay time parameter.

Reverb Gate Status (configs 1, 2, 5, 6, 7)

The display shows:
The level of natural, acoustic reverb decays gradually to zero. Gated
reverb abruptly shuts off the reverb ÒtailÓ after a user-settable elapsed
time. The next few parameters control the time the gate stays Òopen,Ó the
amount of time it takes to Òclose,Ó and the residual reverb level that
remains after the gate has closed.
NOTE: Don't confuse the Reverb Gate Status parameter with the Noise
Gate parameter found in the preamp section. The Reverb Gate is a
function of the Reverb section.

Reverb Gate Hold Time (configs 1, 2, 5, 6, 7)

The display shows:
This parameter sets the amount of elapsed time (00-99) before the gate
closes and cuts off the reverb tail.
HIGH FREQUENCY
DECAY: - 4 0
REVERB GATE:
O N
REVERB GATE HOLD
TIME: 0 0
42