Edit The Program Change Table - Alesis GT Reference Manual

6.3 EDIT THE PROGRAM CHANGE TABLE

The display says:
The lower left, three-digit number represents the incoming program
change number. The lower right, two-digit number represents the
QuadraVerb GT program that will be selected in response to the
displayed program change number. In a new QuadraVerb GT, the two
numbers should be equal up to MIDI program change number 100. At
that point, the QuadraVerb GT program numbers start over again (i.e.,
100=00, 101=01, 102=02, etc.).
While this screen is showing, the PAGE UP button moves the cursor
underneath the QuadraVerb GT program number. The PAGE DOWN
button moves the cursor back under the MIDI program change number.
The VALUE buttons change the selected parameter.
To edit the program change table:
1. Select the incoming MIDI program change number with the VALUE
buttons.
2. Press the PAGE UP button to move the cursor under the
corresponding QuadraVerb GT program number.
3. Use the VALUE buttons to select the desired QuadraVerb GT program
number.
4. To do more edits, press the PAGE DOWN button to return the cursor
to the incoming MIDI program change parameter.
5. Repeat steps 1-4 until the table is completely edited.
PROGRAM TABLE:
0 00 = 00
99