Program Change Enable - Alesis GT Reference Manual

6.2 PROGRAM CHANGE ENABLE

The display says:
There are three options.
¥ Off When off, the QuadraVerb GT will ignore any incoming program
changes.
¥ On When on, the QuadraVerb GT will respond to incoming program
change commands. There is a one-to-one correspondence between
program change numbers and QuadraVerb GT programs (i.e., MIDI
program 0 calls up QuadraVerb GT program 0, MIDI program 1 calls
up QuadraVerb GT program 1, MIDI program 43 calls up QuadraVerb
GT program 43, etc.). MIDI programs 100-127 will call up QuadraVerb
GT programs 00-27
MIDI Weirdness Consumer Alert! Not all program change-
generating devices number their programs from 000-127; some
number their programs from 001 to 128 (which would offset all
program numbers by one), others group programs as banks of 8 or 16
programs, and so on. To figure out whatÕs going on, set the
QuadraVerbÕs MIDI Program Change parameter to on, select various
programs on your program change-generating device, and see which
programs are called up on the QuadraVerb GT.
¥ Table This enables a program change table (see next section) that lets
you assign any QuadraVerb GT program number to any incoming
program change number. Example: You can have MIDI program
change 23 select QuadraVerb GT program 75. With Table selected, it is
not necessary to have a one-to-one correspondence between
QuadraVerb GT program numbers and incoming program change
commands.
MIDI PROGRAM
CHANGE: O N
98