Chapter 4 Ð Editing Configuration Parameters; Selecting A Configuration - Alesis GT Reference Manual

CHAPTER 4 Ð EDITING
CONFIGURATION PARAMETERS
In this section, weÕll describe how to select a configuration, then how to
edit the parameters for each configuration. Please refer to the
configuration block diagrams in section 2.2 for details on how particular
mixing and switching parameters work with a particular configuration.
Remember that after selecting a configuration, the PAGE buttons select
the various pages with different parameters. If a page has more than one
parameter, the PAGE buttons also move between those parameters.
Once a parameter is selected, as indicated by a cursor (small underline),
use the VALUE buttons to change the parameter value.
Sampling is such a different type of application that it has its own
chapter. All sampling parameters are covered in that chapter.
Important! In many of the following sections, a diagram will show what
you can expect to see when you call up a particular page. The parameter
value shown for each page will usually be representative, but when you
actually call up the page on the QuadraVerb GT, a different parameter
value from the one shown in the manual may appear.

4.1 SELECTING A CONFIGURATION

1. Select the program whose configuration you want to change or edit.
2. Press the CONFIG button. The LED in the middle of the button will
light.
3. Use the VALUE buttons to select the desired configuration.
32