Alcatel-Lucent OmniSwitch 6850-48 Management Manual page 113

Using SNMP
No. Trap Name
73 vRtrIsisDatabaseOverload
vRtrIsisSystemLevel—Identifies the level to which the notification applies.Routing within an area is referred
to as Level-1 routing. Routing between two or more areas is referred to as Level 2 routing. Each area runs a sep-
arate copy of the basic link-state routing algorithm.
isisSysL1State—Level 1 Routing (1)
isisSysL2State—Level 2 Routing (2)
74 vRtrIsisManualAddressDrops
isisManAreaAddrExistState—The area ID that was ignored when computing routes.
75 vRtrIsisCorruptedLSPDetected
vRtrIsisSystemLevel—Identifies the level to which the notification applies.Routing within an area is referred
to as Level-1 routing. Routing between two or more areas is referred to as Level 2 routing. Each area runs a sep-
arate copy of the basic link-state routing algorithm.
vRtrIsisTrapLSPID—An Octet String that uniquely identifies a Link State PDU.
76 vRtrIsisMaxSeqExceedAttempt
vRtrIsisSystemLevel—Identifies the level to which the notification applies.Routing within an area is referred
to as Level-1 routing. Routing between two or more areas is referred to as Level 2 routing. Each area runs a sep-
arate copy of the basic link-state routing algorithm.
vRtrIsisTrapLSPID—An Octet String that uniquely identifies a Link State PDU.
OmniSwitch AOS Release 6 Switch Management Guide
Objects Family
vRtrIsisSystem- isis
Leve
lisisSysL1 State
isisSysL2 State
isisManAr- isis
eaAddrExist-
State
vRtrIsisSystem- isis
Level
vRtrIsisTrapL-
SPID
vRtrIsisSys- isis
temLevel
vRtrIsisTrapL-
SPID
September 2009
SNMP Overview
Description
This trap is sent when the system
enters or leaves the Overload
state.
This trap is sent when one of the
manual area addresses assigned
to this system is ignored when
computing routes. The object
vRtrIsisManAreaAddrExistState
describes the area that has been
dropped.
This trap is edge triggered, and
should not be regenerated until
an address that was used in the
previous computation has been
dropped.
This trap is sent when an LSP
that was stored in memory has
become corrupted.
The LSP ID is forwarded. The ID
may be known, but in some
implementations there is a
chance that the ID itself will be
corrupted.
This trap is sent when the
sequence number on an LSP
wraps the 32 bit sequence
counter.
page 3-27