Alcatel-Lucent OmniSwitch 6850-48 Management Manual page 107

Using SNMP
No. Trap Name
42 gmBindRuleViolation
gmBindRuleType—Type of binding rule for which trap sent.
gmBindRuleVlanId—Binding Rule VLAN Id.
gmBindRuleIPAddress—Binding Rule IP address.
gmBindRuleMacAddress—Binding Rule Mac Address.
gmBindRulePortIfIndex—The ifIndex corresponding to the mobile port on which the binding rule violation
occurred.
gmBindRuleProtoClass—The encoded protocol number used for binding VLAN classification.
gmBindRuleEthertype—Ethertype value for generic Ethertype or snap rule. This value has no meaning for
vProtoRuleProtoClass set to values other than 9 or 11.
gmBindRuleDsapSsap— DSAP and SSAP values for generic DSAP/SSAP and SNAP rules. This value has no
meaning for vProtoRuleProtoClass set to values other than 10.
43 unused
44 unused
45 unused
46 unused
47 pethPsePortOnOff
pethPsePortDetectionStatus—Describes the operational status of the port PD detection. A value of disabled
(1)- indicates that the PSE State diagram is in the state IDLE. A value of searching (2)- indicates that the PSE
State diagram is in the state DETECTION, CLASSIFICATION, SIGNATURE_INVALID or BACKOFF. A
value of deliveringPower (4) - indicates that the PSE State diagram is in the state POWER_UP, POWER_ON or
POWER_OFF. A value of fault (5) - indicates that the PSE State diagram is in the state TEST_ERROR or the
state IDLE due to the variable error condition. Faults detected are vendor-specific. A value of test (7) - indicates
that the PSE State diagram is in the state TEST_MODE. A value of denyLowPriority (8) indicates that the port
was disabled by the power management system, in order to keep active higher priority ports.
Note: This trap is not supported on OmniSwitch 6400, 6800, 6850, and 6855 switches.
OmniSwitch AOS Release 6 Switch Management Guide
Objects Family
gmBindRule- vlan
Type
gmBindRuleV-
lanId
gmBindRuleI-
PAddress
gmBin-
dRuleMac-
Address
gmBindRule-
PortIfIndex
gmBin-
dRuleProto-
Class
gmBindRu-
leEthertype
gmBindRuleD-
sapSsap
N/A N/A
N/A N/A
N/A N/A
N/A N/A
pethPsePortDe- module
tectionStatus
September 2009
SNMP Overview
Description
Occurs whenever a binding rule
which has been configured gets
violated.
Indicates if power inline port is
or is not delivering power to the a
power inline device.
page 3-21