Rinnai RS100 Training Program page 16

RS100 User Buttons
Information
display
• Outside—displays current outside temperature reading from the outdoor reset sensor
• Pressing the dial will show the average temperature over the last 24 hour period
• Out. Min/Max—displays the low and high temperatures recorded over the last 24 hour period
• NOTE: Outside information will not display if there is not an outside sensor (T4)
• Heat Gener.—displays the current boiler supply water temperature (T1)
• Pressing the dial will show the average temperature over the last 24 hour period
• Modulation—Shows percentage of modulation when boiler is in operation
• Hydrau. Press—displays current pressure in Bar as detected by the boiler pressure sensor (P1)
• To convert to PSI multiply by 14.7
• DHW—displays temperature of DHW sensor (T3). If no DHW sensor is in use display will indicate ―OFF‖ or if
an ON/OFF type sensor is used for an indirect tank display will indicate that sensor's current state (ON/OFF)
• Pressing the dial will show the current temperature set point
• Combi models will not display this temperature as it is controlled internally.
• Room temp HC—displays current room temperature
• Pressing the dial will show the average temperature over the last 24 hour period
• Auto-P1 Day DHW; and,
• Auto-P1 Day HC—Both of these will display the following for heating or DHW
• Operational mode: Auto, Holiday, Absence, Party, etc
• P1 indicates the current program. This will not show if P1-P3 is not activated
• Boiler status: ON indicates the pump (and diverter valve) is servicing this side of the system (DHW or HC)
NOTE: Holding the Info button for 3 seconds will allow adjustment of the time these values will display (0.5-10
minutes). OFF will allow the display to follow the System setting (default 2 minutes).
Briefly pressing this button displays the following information
(turning the dial clockwise will advance to the next reading):
www.rinnai.us • © 2009 Rinnai America Corporation
16