C) Playing - Roland Kiwitechnics KIWI-SJX Manual

C) Playing

www.kiwitechnics.com
Load Sequence
A Sequence can be loaded in two
ways. A Sequence is loaded manually
by pressing SEQ LOAD followed by a
Number Pad Button
Sequence that is stored under the
Number Pad button selected will be
loaded to memory
.
A Sequence can be assigned to a
Tone and can load automatically
when the Patch including that tone is
loaded. To do this place the Sequence
number 1-8 in the Load Sequence
Field in the Tone Parameter Editing
(midi editing only) or save the Tone
with the sequence running. Place a
zero in this field if you do not want a
Sequence to load or save the tone
with the sequence stopped. The last
Sequence will stay in memory and
continue to play (if enabled) in this
case.
Note: The sequence output will follow
the currently selected Patch Key
mode rules, Whole, Dual or Split.
If you press the SEQUENCER button
the indicator on the button will light
and the data written
sequencer will be played.
note of the sequence will only sound
once a clock has been received.
allows a seq to be queued to start.
When all the notes are played the data
will return to the beginning and be
played again from the start. Pressing
the SEQUENCER button once more
will stop the sequence
immediately. The tempo of the playing
will be determined by the clock
source. If the clock source is the
Internal Clock then the tempo will be
set by the Master Clock. Both clock
sources can be further divided using
the SEQ STEP TIMING button.
* If you stop the Sequence part
way through and then restart it
the data will start from the
beginning.
1-8. The * If you wish to only play the data
once, put some rests are the
end so it is easier to stop the
sequence in the correct place.
It is possible to play along with the
sequencer. The Sequence output
follows the same rules as playing
notes. The sequencer output uses 1-
6 of the available voices which can
be up to 12 if Whole mode or 6 if
Dual mode is in use. Beyond this the
note stealing rules that have been
specified in parameter 431 (Voice
Steal Mode).
Note - If a new sequence or Patch is
loaded while a sequence is playing
the load of the Patch and Seq will
delay until the current sequence
reaches the end and is about to loop
back to the start At this point the
Patch and Sequence (if auto load
enabled) will then load and the next
note(s) to sound will be with the new
selection.
into the
The first If the Sequencer is on (Sequencer
Button light on) when a Patch or Tone
This is saved
automatically load when the patch is
selected.
playing
JX-SJX Upgrade User Manual v100
28
the Sequencer will