Table of Contents
Advertisement
Table 1.0 Command ID
$1c (28) Request Patch Edit Buffer
Dump
$1d (29) Transmit or Receive Patch
Edit Buffer Dump
2 Nulls + 269 data bytes
www.kiwitechnics.com
Data Byte
$02 (2) - Parameter Value (Lo)
Bank Number
Patch Number
$00-$13
(0-19) = Patch Name
$14 (20)=Patch Key Mode
$15 (21)=Split Point
$16 (22)=Patch Voice Mode
$17 (23)Lower/Upper Balance
$18 (24)=Overall Patch Volume
$19 (25)=Arp Control
Data Type
Data Details
Byte details
7 ------- 0
0yyyyyyy
Hi & Lo are combined to make single 12 bit command.
000xxxxx + 0yyyyyyy = 0000xxxx xyyyyyyy
JX-10/MKS-70 transmits a $12 (18) command
0
Not used – set to null
0
Not Used – set to null
Ascii Bytes
20 bytes of Patch Name
000000xx
xx =
00=Whole
01=Dual
10=Split
0xxxxxxx
x =
Note number for split point
Note - Only active when mode is set to Split Mode
Only notes the same or higher than this note
will sound on the Right voice board
All notes below this note will sound on the
Lower voice board
00000yyy
yyy = 000=Steal Oldest Voice
001=Steal Newest Voice
010=Steal Highest Voice
011=Steal Lowest Voice
100=Steal Quietest Voice
101=Steal Off (7
0xxxxxxx
x =
Lower/Upper Balance (0=Lower Only)
0xxxxxxx
x = Range $00-$7f (0-127)
This is the total synth volume. This control will set
the overall output of both voice boards
00yyy0zz
zz =
00=1Oct,01=2Oct,10=3Oct,11=4Oct
yyy =
000=Up,001=Dn,010=U/D,011=Rndm,100=As Played
JX-10/MKS-70 Upgrade User Manual v100
71
th
note ignored)
Advertisement
Table of Contents
