Tone Key Mode Button; Patch Chord Button; Global Tempo/Master Clock Button; Key Transpose - Roland Kiwitechnics KIWI-SJX Manual

TONE KEY MODE
BUTTON
PATCH CHORD
BUTTON
GLOBAL
TEMPO/MASTER
CLOCK BUTTON

KEY TRANSPOSE

www.kiwitechnics.com
The TONE KEY MODE button will select
one of five Tone Key Mode types using
the Alpha Dial. Changes will only apply to
the currently selected voice board. In the
MKS-70 version this key is accessed
using the SHIFT Patch Key Mode.
POLY SINGLE – Each note played will
select a single sounding voice. A
maximum of 6 notes can be played.
The CHORD button allows Chords to be
set or cleared. To set a chord play the
chord near middle C & press and release
the CHORD button while the keys are
being held. The Chord Light will be lit
when a chord is set.
The GLOBAL TEMPO BUTTON is used to
set the master internal clock rate. This is
done by pressing and releasing the
GLOBAL TEMPO button and setting the
speed using the ALPHA DIAL. The speed
range can be set from 5 BPM to 299 BPM.
Press the GLOBAL TEMPO Button again
to return to the previous mode.
The Kiwi-SJX JX-10 Key Transpose can be
changed using this button.
While the Key Transpose Button is
pressed, press the note you wish to
transpose to on the keyboard. Then
release the Key Transpose button. The
current transpose will show on the display
while the button is pressed.
POLY DUAL – Each note played will
select two sounding voices. A
maximum of 3 notes can be played.
POLY TRIPLE – Each note played will
select three sounding voices. A
maximum of 2 notes can be played.
UNISON – Only the last note played
will select 6 sounding voices.
SOLO – Only the last note played will
select 1 sounding voice.
Each note played with the chord set
will be used as the base note for the
chord. Keying will behave the same as
Unison or Solo and some keying
mode parameters will not have any
effect.
To clear a chord press and release the
Chord Button with no keys pressed.
The Chord light will turn off.
In the MKS-70 version to perform a
FACTORY RESET hold WRITE and
CHORD buttons must be held down
as you power on the synth.
Warning – this will clear all memory
in the synth and there will be no
confirmation.
The Master Clock source can be
selected from one of 2 sources using
Global parameter edit G4B3T4.
1) Internal clock
2) Midi
The Light above the Transpose Key
will light whenever there is a transpose
set to anything other than middle C.
This option is not available in the
MKS-70 version of the Kiwi-SJX.
JX-SJX Upgrade User Manual v100
15