Programming A Second Indoor Station At A Bell Button (Parallel Call) - TCS PUK Series Product Information

Programming a second indoor station at a bell button (parallel call)

The parallel call is calling 2 indoor stations from the bell button of the front-door station.
The floor push button is only calling the permanently wired indoor station.
If bell button and floor push button are to have the same functionality, the function parallel
allocation must be used. Thus several indoor stations are reacting on the same bell button
as well as on the same floor push button. The parallel allocation has to be adjusted with
the Service Device TCSK-01 or the configuration software configo
Note: Repeated programming of an already programmed bell button always changes only the second serial number. If
you want to change the serial number programmed first, you have to delete both serial numbers and reprogram the
device again.
1 Initiate
Power supply and control unit
press shortly
2a Programming via voice communication
or
establish voice com-
munication to
the front-door station
2b Alternatively: programming via floor push button
+
press floor push button
for 2 times in quick
succession, each time
a ring tone sounds
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88
FAX: +49 (0) 41 94/ 9 88 129  Mail: info@tcsag.de
LED blinks
◄6s►
press button until a Prog2
tone and a NoProg tone
sounds ...
◄6s►
press button until a Prog2
tone and a NoProg tone and
...
Repeat the steps, until all bell buttons are programmed
11
programming mode of the system is ON
◄6s►
... a ring tone sounds at
the front-door and indoor
station
(if the indoor station is not accessible)
◄6s►
... a ring tone at the front-
door and indoor station
sounds
TM
.
1)
1))
Subject to technical changes.
PI_PUK-uk 1 A
11/2012
release
release