Programming A Second Indoor Station To A Bell Button - TCS AMI1090 Series Product Information

01/2013
2a
oder
Establish voice connection to
the front-door station
2b alternatively: via floor push button (indoor station is not available)
+
Shortly press the floor push
button two times, every time
a ring tone sounds
3
Power supply and control unit
Shortly press the:
RUN/PROG push button LED is on
1) If there is no response, the programming lock of the bell button module is activated. The programming
lock can only be deactivated with a Service Device TCSK-01 or the configuration software configo

Programming a second indoor station to a bell button

If two indoor stations are to be called by pressing one bell button, the serial number of the
second indoor station can be allocated additionally to this bell button.
Note:
A repeated programming of an already programmed bell button changes only the second
serial number.
TCS TürControlSysteme AG, TCS Hotline Deutschland: hotline@tcsag.de
www.tcsag.de
7
Via voice connection
Shortly press the button,
positive acknowledgement
Shortly press the button,
positive acknowledgement
Repeat the steps until all bell buttons are programmed.
End
Nameplate of the bell button module ON (or OFF).
Programming mode of the system is switched off
... a ring tone sounds at the front-door
1)
and indoor station
... a ring tone sounds at the front-door
station and at the indoor station
or
Subject to technical changes.
PI_AMI1090x-uk
1)
TM
.
1A