Parker PDHX-E Series User Manual page 33

Selftest Switch1
The selftest switch is used to check the operation of the drive. Set to the ON position to
cause the motor to rotate at slow speed. The default setting of selftest is OFF i.e. not
selected.
Standby Switch 2
Switch 2 determines the level of standby current. With switch 2 ON, the current will reduce
by 50% at standby. With switch 2 OFF, current will be reduced to 80% of the programmed
value at standby.
Step Resolution Switch 4, 5
DIP Switches 4 and 5 determine the step resolution of the drive, as defined in Table 3-11.
Note: cycle the power for switch settings to take effect.
Peak Current Setting Switch 6, 7, 8
DIP Switches 6, 7 and 8 determine the peak current setting of the drive, as defined in
Table 3-12.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SWITCH RESOLUTION
SETTINGS IN
STEPS/REV
4 5
ON ON 400
ON OFF 1000
OFF ON 2000
OFF OFF 4000
Table 3-11. Step Resolution Settings
SWITCH SETTINGS
6 7 8
ON ON ON
OFF ON ON
ON OFF ON
OFF OFF ON
ON ON OFF
OFF ON OFF
ON OFF OFF
OFF OFF OFF
Table 3-12. Peak Current Settings
PEAK
CURRENT
5.0A
4.6A
4.3A
3.9A
3.6A
3.2A
2.9A
2.5A