Parker PDHX-E Series User Manual page 17

Drive-end connections
Fit the ferrite absorber supplied over the motor cable. Connect the five leads in the motor
cable to the motor connector as shown in Fig. 3-1. Expose a short length of the cable screen
and anchor it to the drive using the metal P-clip located below the mains input connector.
Locate the absorber between the P-clip and the motor connector, retaining it in place with the
heat-shrink sleeving supplied. The specification of a suitable absorber is given below. Fit the
insulated cover supplied with the drive over the motor connector to protect any exposed wires
and screw terminals.
Ferrite absorber specifications
The absorbers described in these installation instructions are made from a low-grade ferrite
material which has high losses at radio frequencies. They therefore act as a high impedance
in this waveband.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
MOTOR CONNECTOR
MOTOR
Figure 3-1 PD-E Drive Motor Connections
A+
A-
Gnd
B+
B-
FERRITE
ABSORBER
P CLIP
MOTOR
HOUSING