Sequential Data Analysis - HP E1725C Getting Started Manual

NOTE
4
1
2
3
4
5
Chapter 3 Practice Using the TIA Software
TIA Software Tutorial
The segment enable/disable and activate features also work when
Segment>Combined segments is selected, or if a one-sided result has
been chosen. Also, all the these features are available with the
Segmented-Histogram display.
Select WindowMargin>Show results.
This is a tabular listing of window margin results for each enabled
segment. This window also responds to changes in the combined/overlaid
selection and one-sided/two-sided selection.
The data from this window can be copied to the clipboard using the
Edit>Copy selection. Demo 4 in this guide illustrates this feature.

Sequential Data Analysis

All of the tasks so far have dealt with using histogram data. The software
can also acquire data as measured value versus the time-of-occurrence.
The Sequential record mode preserves the sequence of time interval
measurements and the precise time of occurrence. This information is not
available when using the fast histogram mode.
Select the TIA Setup window again.
Set the Record Mode to sequential.
Select Display>Versus-Time.
Click the Run button.
Data is now being stored into sequential memory. What you see on the
Versus-Time display are the 1000 interval measurements displayed as a
function of time.
Click on the Stop button.
Getting Started Guide 3-17