3. Remove the ground screw [A] at the rear of the paper tray unit.
4. Fasten the heater [B] and the supplied
ground wire [C] to the paper tray unit
with 3 screws as shown. Note that [A]
is the grounding screw you removed
at Step 3 (returned to its original hole),
and [D] and [E] are the two supplied
heater fastening screws.
NOTE: Be sure to position the ground
wire [C] and heater harness
[F] so that they will be out of
the way of the copier when
you set it onto the paper tray
unit.
5. Set the copier onto the paper tray unit.
6. Screw the paper tray unit into place using
three supplied PTU fastening screws.
SM
PAPER TRAY UNIT HEATER
[D]
[F]
[B]
[E]
1-13
[C]
[A]
B046I519.WMF
B046I500.WMF
B044/B045/B046