Nib (B430) - Ricoh Aficio 1013 Service Manual

NIB (B430)

1.5 NIB (B430)
!
CAUTION
Unplug the main machine power cord before starting the following
procedure.
NOTE: To install the NIB option, the printer option (B441) must be installed also.
Please refer to section 1.2 for the printer controller installation procedure.
The display takes a few minutes to initialize after installing the NIB.
[A]
[C]
[D]
1. Remove the rear cover [A] (5screws)
2. Remove the controller board [B] from the machine (1 harness and 8 screws or
6 screws if no fax option).
3. Remove the small window [C] on the controller board bracket.
4. Connect the network interface board [D] to the controller board (2 screws) as
shown.
5. Replace the controller board assembly in the machine.
6. Replace the rear cover.
7. Wrap the network cable around the core [E], close the core, then connect the
cable to the machine.
B441
[B]
B441I501.WMF
B441I506.WMF
1-6
[E]
B441I108.WMF
B441I503.WMF
SM