Fuse Block And Fuses; Testing - Toro Z Master 7500-D Series Service Manual

Fuse Block and Fuses

The fuse block houses the fuses that protect the electrical system from electrical surges (Figure 3).
NOTE: Always use OEM fuses when replacing a damaged or blown fuse.

Testing

1. Visual Inspection: The fuses used in this application may be visually inspected. A failed fuse can be identified
by a broken or melted element inside the fuse cover or a damaged spade (Figure 4).
2. Using a digital multi-meter set to the OHM or continuity setting, check the continuity between the fuse blades. If
the fuse is OPEN (no continuity), replace the fuse and test the circuit.
8-6
Table of Contents
ELECTRICAL
Figure 3
Bad
Good
Figure 4
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition