Front Seat Mount
Removal
1. Park the machine on a level surface, disengage the PTO, and engage the parking brake. Stop the engine, wait
for all moving parts to stop and remove the key.
2. Remove the operator's seat,
3. Mark the location of the motion control plate with tape to assure proper alignment upon installation (Figure 16).
4. Remove the four screws (two on each side) securing each left and right motion control covers to the machine.
5. Remove both left and right motion control covers from the machine.
6. Remove the floor pan from the machine.
7. Using a flat head screw driver, remove the two black clips on the front seat mount (Figure 17).
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
CHASSIS
see "Seat Removal," chapter 5, page 5-23.
Figure 16
Figure 17
5-25
Table of Contents