Fuse Block And Fuses; Key/Ignition Switch - Toro TITAN Max Service Manual

Fuse Block and Fuses

Fuse Block and Fuses Test

Key/Ignition Switch

Electrical System: Service and Repairs
The fuse block houses the fuses that protect the electrical system from electrical
surges.
Note: Always use Toro fuses when replacing a damaged or blown fuse.
1. Visually inspect the fuses. A failed fuse can be identified by a broken or
melted element inside the fuse cover or a damaged spade.
g336414
2. Using a digital multi-meter set to the OHM or Continuity setting, check the
continuity between the fuse blades. If the fuse is OPEN (no continuity),
replace the fuse and test the circuit.
The ignition switch makes the proper connections for the starter, safety
circuits, and accessories. Detents inside the switch control the three switch
positions: OFF, RUN, and START. The START position is spring loaded so that it
automatically returns to the RUN position when released.
Ignition Switch Wiring Connections
•
B - Battery Voltage In
•
S - Starting Circuit
•
I - PTO Switch
•
A - Operator Presence Switch, Safety Interlock Switches
•
R - Regulator, Charging Circuit
Figure 107
Page 8–4 TITAN® Max Service Manual
3442-428 Rev A