Assembling The Mower - Tm5490 - Toro TM5490 Operator's Manual

1.26
Assembling the Mower continued
6. Modify the cylinder adjustment handwheel
assemblies (Item 8) on cutterhead 3 to the
angled back position. Remove the nuts, bolts
and washers from alternative hole positions
'A'. Remove the nuts, bolts and washers which
attach the handwheel assemblies to cutterhead
frame. Remove the ring bolt clamp nuts,
washers and spring washers and remove the
handwheel assemblies. Adjust the handwheel
assemblies to provide the correct fastening
centres and refit in the alternative positions.
Replace all fasteners and tighten securely.
7. Secure the cutterheads to the mower in the
correct positions using the pivot pins, M24
nylon nuts, plain washers, nut caps, pin
retainers, belleville washers (where applicable),
M12 x 25 setscrews and spring washers (Items
21, 22, 20, 25, 30, 23 & 24 - pages 1.23).
Note that cutterheads 2 & 4 mount in front of
their respective suspension arms.

ASSEMBLING THE MOWER - TM5490

Note:
Cutterhead 3 -
adjusters angled to rear
as shown.
1.26