Table of Contents
Advertisement
1.72
MAINTENANCE
1.72
Cutterhead Bottom Blade Replacement
continued
The new bottom blade must be ground on its holder
prior to refitting to the cutterhead. Adjust the cut-
ting cylinder position to give adequate clearance
for fitting the new bottom blade holder. Refit the
bottom blade holder assembly to the cutterhead us-
ing the original fixing bolts and tighten to a torque
of 35Nm (26 lbf.ft). Finally adjust the cylinder to
the bottom blade, refer to CUTTERHEAD CYL-
INDER TO BOTTOM BLADE ADJUSTMENT.
Advertisement
Table of Contents
