Table of Contents
Advertisement
1.48
OPERATING THE MOWER
1.48
Cutterhead Position Controls (Electrical
Control)
The remote control cutterhead position controls
include an override control switch and three indi-
vidual lift/lower control switches.
N
Override control switch: Push the override con-
trol switch (A) away to lower cutterheads simul-
A
taneously and pull backwards to raise cutterheads
simultaneously.
Note: This function will only operate on cutter-
heads where the individual control switches are in
the 'Down/Cut' position.
The cutterhead drive will disengage quickly when
the override control switch is operated to raise the
cutterheads or moved to the 'Neutral' position. The
cutterhead drive will engage approximately 300 -
400mm above the ground level when the override
control switch is operated to lower the cutterheads.
For identification of controls please refer to page
1.13.
Lift/Lower control switches: Push the lift/lower
control switches away to lower the cutterheads
independently. The cutterhead drive will engage
approximately 300 - 400mm above ground level.
N
N
N
Pull the lift/lower control switches backwards to
raise the cutterheads independently.
Note: The lift/lower control switches will only
B
C
D
operate when the override control switch (A) is in
the 'Down/Cut' position.
Override control switch 'A' operates all cutter-
heads.
Lift/Lower control switch 'B' operates left hand
wing cutterhead.
Lift/Lower control switch 'C' operates central
three/five cutterheads.
Lift/Lower control switch 'D' operates right hand
wing cutterhead.
Advertisement
Table of Contents
