Table of Contents
Advertisement
1.66
Every 250 Hours continued
Inspect the brakes shoes for wear: Remove the
wheel hubs and inspect the brake shoes. The shoes
must be replaced if the lining thickness is less than
1.5mm. Use genuine Toro replacement parts. Do
not reline brake shoes.
Inspect the brake wedges: Check that the brake
wedges operate the brake shoes correctly. Wedges
which are worn excessively will not apply the
brakes fully and must be replaced.
Examine the brake cables: Ensure that the brake
cables operate freely and that there are no signs of
fraying or other damage. Always replace damaged
cables.
Examine linkages: Ensure that all brake link-
ages are in good condition, operate freely and are
secured correctly. Lubricate pivot points with oil.
Examine cylinder: Check the brake cylinder and
the associated hydraulic hoses for leaks. Always
replace any leaking components.
Inspect the jockey wheel assembly: Examine the
wheel and tyre and ensure that they are in good
condition. Check that the jack is in good condi-
tion and operates freely. Replace worn or damaged
components.
Every 500 Hours
Perform routine checks: Refer to DAILY BE-
FORE USE, EVERY 50 HOURS AND EVERY
250 HOURS USE.
Thoroughly clean the machine.
Service the hydraulic system: Lower the cutter-
heads to the ground and drain the hydraulic oil by
removing the hydraulic tank drain plug. Remove
the oil tank filler flange to gain access to the strain-
er inside the tank. Unscrew and remove the strainer
and clean in paraffin before replacing. Renew the
strainer if it is damaged.
Renew the return line oil filter element, refer to
RUNNING IN PERIOD - AT FIRST 50 HOURS
OF USE.
Replace the drain plug and refill the hydraulic
tank with new hydraulic oil, refer to SPECIFICA-
TIONS.
MAINTENANCE
1.66
1. Brake shoe
2. Spring
1
2
Advertisement
Table of Contents
