Table of Contents
Advertisement
1.50
Cutterhead Drive Direction Control
(Electrical Control) continued
WARNING: PREVENT ACCIDENTS - For full
safety isolation disengage the tractor PTO drive
and lower the cutterheads to the ground.
WARNING: PREVENT ACCIDENTS - For full
safety isolation disengage the tractor PTO drive
and lower the cutterheads to the ground. To
restore the electrical lift control system after the
emergency stop button has been operated:
1. Ensure the tractor PTO drive is disengaged.
2. Set all five cutterhead / position control
switches to the 'Neutral' position.
3. Turn the Emergency Stop button clockwise
to release and allow it to return to the normal
'ON' position.
4. Refer to 'Operating The Mower' and engage
the tractor PTO drive.
5. Electrical lift control should now be restored.
Manual override control valve: In the event of
total electrical failure the cutterheads can be lifted
into the transport position using the manual over-
ride control valve as follows:
1. Ensure that the immediate area is entirely
clear.
2. Ensure that the tractor parking brake is applied,
the PTO drive is disengaged, the engine has
stopped and the ignition key is removed.
3. Set all cutterhead arm transport latches to the
automatic latching position as shown.
4. Locate the manual override control valve (A)
and screw in the operating screw fully.
5. Start the tractor and set the engine speed to a
slow idle.
6. Operate the tractor rear PTO and allow all
cutterheads to raise into the transport
position until the transport latches are
automatically engaged.
7. Disengage the tractor rear PTO and stop the
engine.
OPERATING THE MOWER
1.50
Advertisement
Table of Contents
