Table of Contents
Advertisement
1.49
Cutterhead Drive Direction Control
(Electrical Control)
Note: The cutter head drive switch (E) will only
operate when the override control switch (A) is in
the down/cut position.
Forward rotation cutterhead drive engagement:
Operate the cutterhead drive switch to the 'For-
ward' position.
Reverse rotation cutterhead drive engagement:
Operate and hold the cutterhead drive switch to the
'Reverse' position.
This control is intended for cutterhead blockage
removal only and should not be used for backlap-
ping. Refer to MAINTENANCE - BACKLAP-
PING.
To disengage all cutterhead drives: Operate the
cutterhead drive switch to the 'Off' position or
operate the override control switch to the 'Neutral'
position and or disengage the tractor PTO drive. In
an emergency, operate the emergency stop button.
Operate the override control switch to the 'Neutral'
position and/or disengage the tractor PTO drive. In
an emergency, operate the emergency stop button.
Power indicator: The power indicator light will
illuminate when electrical power is fed to the
electrical control box. If the indicator fails to light,
check the electrical supply connection to the trac-
tor.
Note: When the indicator is unlit the lift control
system is inoperative.
Emergency stop button: Operation of the emer-
gency stop button performs the following actions:
1. All cutterhead drives are disengaged.
2. All cutterhead lift mechanisms are
hydraulically locked and the cutterhead
suspensions are frozen in the position at which
the emergency stop button was operated. The
cutterheads/suspensions will remain in this
condition supported solely by the hydraulic
system.
3. The electrical lift control system is disabled.
OPERATING THE MOWER
E
FORWARD
OFF
REVERSE
1.49
Advertisement
Table of Contents
