Table of Contents
Advertisement
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use the chart below to identify parts used for assembly.
Description
Discharge chute
Spring
Bolt, 3/8 x 3-1/2 in.
Locknut, 3/8 in.
Pulley box
PTO drive belt
Assembling the Mower
Installing the Discharge Chute
1. Place the springs into the brackets on the mower with
the hooked ends over the raised back of the bracket
(Fig. 2).
5
4
Figure 2
1. Bracket
2. Spring hook end
3. Space for spring
2. Align the discharge chute with the holes in the brackets
and the spring straight ends in the space under the hinge
and above the chute (Fig. 2).
3. Secure the chute to the bracket with bolts through the
discharge chute, springs, and brackets. Secure them
with locknuts (Fig. 2).
6
1
3
2
m–3484
4. Discharge chute
5. Bolt
6. Locknut
Qty.
1
2
Install discharge chute
2
2
1
Install the PTO drive belt
1
4. Lift the discharge chute and check that it is spring
loaded and snaps freely to the full down position.
Important
The discharge chute must be spring loaded
in the down position.
Danger
Without the grass deflector mounted in place, you
and others are exposed to blade contact and
thrown debris. Contact with the rotating mower
blades and thrown debris will cause injury or
death.
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
Never put your hands or feet under the mower.
Never try to clear the discharge area or mower
blades unless you move the power take off
(PTO) to Off and rotate the ignition key to Off.
Also remove the key and pull the wires off of the
spark plugs.
Mower Belt Routing
Route the mower belt as shown in Fig. 3. Ensure that you
install the belt on the lower mower deck pulley.
4
Use
Advertisement
Table of Contents
