Table of Contents
Advertisement
1.19
Specifications
ALL FIGURES ARE NOMINALLY QUOTED AT THE RATED PTO SPEED OF 540 RPM UNLESS
OTHERWISE STATED.
Hydraulic System
Drive Type:
Hydraulic Oil Type:
Tank Capacity:
Total System Capacity:
Suction Line Filtration:
Return Line Filtration:
Delivery Rate to Cutterheads:
Delivery Rate to Lift Controls:
Cleanliness Level:
Maximum Oil Temperature:
Recommended Lubricants and Hydraulic Fluids
Grease Points:
Cutterhead Grease Points:
PTO Gearbox:
Hydraulic System:
Ambient Temperature Range
0 - 30̊ C (32 - 86̊ F)
ISO viscosity grade
46 hydraulic oil
Should you be in any doubt please contact your Toro dealer. Using incorrect grades will cause premature wear of
hydraulic components and invalidate warranty.
PTO Gearbox
Input:
Capacity:
Output:
SPECIFICATIONS
PTO gearbox / twin tandem gear pumps
Refer to RECOMMENDED LUBRICANTS AND HYDRAULIC
FLUIDS
133 Litres
142 Litres
125 micron no bypass mesh filter
10 micron with bypass check valve, 2 bar (29 psi)
29.5 Litres/min
15 Litres/min
ISO Code 18/13 or better (ISO 4406)
1300 - 2500 Particles/ml <15µ
40 - 80 Particles/ml >15µ
95̊ C (203̊ F)
A good quality medium grease
A good quality medium grease
EP90 gear oil.
15 - 40̊ C (59 - 104̊ F)
ISO viscosity grade
68 hydraulic oil
540 rpm 1.3/8" 6 spline PTO shaft, anti-clockwise rotation (Looking on end of
shaft)
1 Litre. Refer to RECOMMENDED LUBRICANTS AND HYDRAULIC
FLUIDS
1862 rpm at pump coupling
1.19
Advertisement
Table of Contents
