Table of Contents
Advertisement
1.61
MAINTENANCE
1.61
Running In Period
During first 50 hours of use and in addition to rou-
tine checks, refer to DAILY BEFORE USE.
Check wheel nut torque settings before use.
Wheel nut torque setting - 224 Nm.
At first 50 hours of use and in addition to rou-
tine checks, refer to DAILY BEFORE USE.
Adjust the brake system.
WARNING: PREVENT ACCIDENTS -
Ensure that the mower is securely coupled to the
tractor, refer to ATTACHING THE MOWER
TO THE TRACTOR. The mower should be
standing on level ground with the handbrake
applied.
Carefully lower the mower handbrake to release
the brakes.
Adjust the wheel brake shoes. Jack the mower
and block securely such that the wheels are raised
above the ground. Rotate the L.H. wheel in the
BRAKE
direction of forward travel by hand and turn the
ADJUSTER
brake shoe adjuster until the wheel cannot be
rotated (pre-load the brakes). Turn the brake ad-
juster back in increments of half a turn, tapping the
BRAKE
adjuster after each increment until the wheel can be
BACKPLATE
rotated by hand against slight resistance. The brake
shoe is now correctly adjusted. Repeat this process
on the R.H. wheel.
Lower the wheels to rest on the ground.
At first 50 hours of use and in addition to rou-
tine checks, refer to DAILY BEFORE USE AND
EVERY 50 HOURS USE.
Change the hydraulic oil return filter. Remove the
top of the return filter assembly. Withdraw the filter
element canister and discard. Refit a new filter
canister (Toro part No: 65-06-483) and replace the
screw top taking care to ensure that the 'O' ring
seal is correctly located.
65-06-483
Advertisement
Table of Contents
