Replacing The Grass Deflector - Toro Z Master Professional 7000 Series Operator's Manual

Installing the Blades
1. Install the blade onto the spindle shaft
113).
Important:
The curved part of the blade
must be pointing upward toward the inside
of the mower to ensure proper cutting.
2. Install the spring disk and blade bolt
113).
Note:
The spring-disk cone must be installed
toward the bolt head
3. Torque the blade bolt to 115 to 150 N∙m (85 to
110 ft-lb).
Figure 113
1. Sail area of the blade
2. Blade
(Figure
(Figure
(Figure 113).
3. Spring disk
4. Blade bolt
Replacing the Grass
Deflector
Side Discharge Machines Only
WARNING
An uncovered discharge opening could allow
the machine to throw objects toward you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
• Never operate the machine unless you
install a cover plate, a mulch plate, or a
grass chute and catcher.
• Make sure that the grass deflector is in the
down position.
1. Remove the locknut, bolt, spring and spacer
holding the deflector to the pivot brackets
(Figure 114).
2. Remove the damaged or worn grass deflector.
3. Place the spacer and spring onto the grass
deflector. Place the L end of the spring behind
the deck edge.
Note:
Make sure that the L end of the spring is
installed behind the deck edge before installing
the bolt as shown in
4. Install the bolt and nut.
g004536
5. Place the J-hook end of the spring around the
grass deflector
Important:
to lower into position. Lift the deflector up to
test that it lowers into the full-down position.
76
Figure 114
(Figure 114).
The grass deflector must be able