Drive System Maintenance; Adjusting The Tracking; Checking The Tire Pressure - Toro Z Master Professional 7000 Series Operator's Manual

Drive System
Maintenance

Adjusting the Tracking

The machine has a knob for adjusting the tracking
located under the seat.
Important:
Adjust the handle neutral and
hydraulic pump neutral before adjusting the
tracking; refer to Adjusting the Control Handle
Neutral Position (page 65)
Hydraulic Pump Neutral Position (page
1. Push both control levers forward the same
distance.
2. Check if the machine pulls to 1 side. If it does,
shut off the machine and engage the parking
brake.
3. Unlatch the seat and tilt the seat forward to
access the tracking knob.
Note:
Determine the left and right sides of the
machine from the normal operating position.
4. To make the machine go right, turn the knob
toward the right of the machine; refer to
77.
5. To make the machine go left, turn the knob
toward the left of the machine; refer to
6. Repeat adjustment until the tracking is correct.
and Setting the
69).
Figure
Figure 77.
1. Tracking knob
2. Hydraulic tank
3. Hydraulic pumps

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut.
Check the tires when they are cold to get the most
accurate pressure reading.
Note:
The front tires are semi-pneumatic tires and do
not require air pressure maintenance.
55
Figure 77
4. Turn this way to track right.
5. Turn this way to track left.
Figure 78
g001070
g001055