Mower Deck Maintenance; Leveling The Mower At 3 Positions - Toro Z Master Professional 7000 Series Operator's Manual

WARNING
The electrical system does not perform
proper safety shut off with the jumper
wire installed.
• Remove the jumper wire from the
wire harness connector and plug the
connector into the seat switch when
you complete the adjustment.
• Never operate the machine with the
jumper installed and the seat switch
bypassed.
7. After both pump neutrals are set, shut off the
machine.
8. Remove the jumper wire from the wire harness
connector and plug the connector into the seat
switch.
9. Install the seat rod and lower the seat into
position.
10. Remove the jack stands.
Mower Deck
Maintenance
Leveling the Mower at 3
Positions
Important:
There are only 3 measuring positions
needed to level the mower.
Setting Up the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Check tire pressure of the tires; if needed, adjust
to 90 kPa (13 psi).
4. Lower the mower to the 76 mm (3 inches)
height-of-cut position.
5. Inspect the 4 chains.
Note:
The chains need to have tension.
Note:
Adjust the rear chains to the top of the
slot, where they are attached to the mower.
•
If a rear chain is loose, lower (loosen) the
front-support arm on the same side; refer
to Adjusting the Front-to-Rear Mower Pitch
(page 72).
•
If a front chain is loose, raise (tighten) the
front-support arm for that chain; refer to
Adjusting the Front-to-Rear Mower Pitch
(page 72).
71