IBM ServeRAID-4 Ultra160 Series User Reference page 79

mount -F cdfs -r /dev/cdrom/cdromdevicefile /mnt
Notes:
a. where cdromdevicefile is the specific device file for the CD-ROM block
device. Look in the /dev/cdrom directory to determine what cdromdevicefile
is on your server, for example, c0b0t010.
b. If you currently have another device mounted on /mnt, you must create a
new directory and substitute its name for /mnt in these instructions.
4. Press Enter; then, type:
cp /mnt/programs/unixware/cmdline/ipssend /usr/bin
5. Press Enter; then, type:
chmod 700 /usr/bin/ipssend
6. Press Enter; then, unmount the CD-ROM by typing the following:
umount /mnt
7. Press Enter. Remove the CD from the CD-ROM drive.
Installing IPSSEND for UnixWare from diskette
To install this program for UnixWare 7.1 from the IBM ServeRAID Command-Line
Programs diskette, do the following:
1. Start the server.
2. After the operating system starts, insert the IBM ServeRAID Command-Line
Programs diskette into the diskette drive.
3. Mount the diskette drive by typing the following at the console:
mount -F dosfs /dev/fd0135ds18 /Disk_A
Notes:
a. If you have more than one diskette drive, you might need to replace
/dev/fd0135ds18 with the specific name of the diskette drive that you want
to use.
b. If you currently have another device mounted on /Disk_A, you must create
a new directory and substitute its name for /Disk_A in these instructions.
4. Press Enter; then, type:
cp /Disk_A/unixware/ipssend.z /tmp/ipssend.z
5. Press Enter; then, type:
zcat /tmp/ipssend.z > /usr/bin/ipssend
6. Press Enter; then, type: rm -f
/tmp/ipssend.z
7. Press Enter; then, unmount the diskette drive by typing the following:
umount /Disk_A
where /Disk_A is the directory you mounted in step 3.
8. Press Enter. Remove the diskette from the diskette drive.
9. Change the access permissions by typing the following:
chmod 700 /usr/bin/ipssend
10. Press Enter.
Chapter 8. Installing and using the IPSSEND command-line program
61