IBM ServeRAID-4 Ultra160 Series User Reference page 135

11. Run IPSHAHTO.EXE from Server A again, so that control of all shared logical
drives returns to Server A.
12. Using the Windows 2000 Disk Management Snap-in Computer Management
program on Server A, verify that the shared logical drives display with the
correct size, volume label, and drive letter.
Note: The drive letters for the shared disks must be the same on each server
in the cluster.
13. Ensure that both servers are turned on.
Note: If you have a two-node cluster that has a private network consisting of
the two servers directly connected to each other using an Ethernet
cross-over cable, make sure that both servers are turned on before you
proceed.
Failure to have both servers turned on will cause Windows 2000 to
mark the network card as failed and you will not be able to select it as
the private network interface during cluster setup.
14. Insert the IBM ServeRAID Windows NT Cluster Solution diskette or IBM
ServeRAID Support CD into the Server A diskette or CD-ROM drive; then, type
the following command and press Enter:
v If you are installing from diskette, type the following command from a
Windows 2000 command line and press Enter:
a:\setup
where a is the diskette drive letter.
v If you are installing from CD, type the following command from a Windows
2000 command line and press Enter:
d:\programs\winnt\cluster\setup
where d is the CD-ROM drive letter.
The SETUP.EXE program copies some files and launches the Windows
Component Wizard.
15. In the Windows Component Wizard, click the check box to install the Cluster
Service component; then, click Next.
16. When prompted, insert the CD labeled Windows 2000 Advanced Server
CD-ROM into the CD-ROM drive; then, click OK. The Microsoft Cluster Service
Configuration Wizard opens.
Note: To configure the Microsoft Cluster Service, follow the instructions in the
Microsoft Cluster Service documentation.
17. After you install and configure the cluster, IBM ServeRAID Cluster
Configuration Wizard opens and applies ServeRAID-specific configurations to
the cluster. When prompted, select a shared ServeRAID logical drive on which
to set quorum.
Note: Set the quorum resources on a RAID level-1 logical drive. Do not set
the quorum resources on a RAID level-5 logical drive.
18. Repeat step 13 through step 16 for Server B. The cluster installation is
complete and the cluster is ready for use.
Chapter 14. Installing the Microsoft Cluster Service software
117