IBM ServeRAID-4 Ultra160 Series User Reference page 102

3. If your CD-ROM drive does not automount, type the following:
4. Press Enter.
5. Type the following command.
6. Press Enter.
7. When the installation is complete, type the following.
8. Press Enter. You can now remove the CD from the CD-ROM drive.
Installing ServeRAID Manager on OS/2
Note: The OS/2 version of the ServeRAID Manager program supports up to 8
To install the ServeRAID Manager program for OS/2, do the following:
1. Insert the IBM ServeRAID Support CD into the CD-ROM drive.
2. Open an OS/2 command window.
3. Type the following:
4. Press Enter; then, type:
5. Press Enter; then, type:
6. Press Enter.
7. The installation program starts. Follow the instructions on the screen to install
Installing ServeRAID Manager on OpenServer
Notes:
1. This version of the ServeRAID Manager program supports up to 8 ServeRAID
84
®
IBM User's Reference: ServeRAID
mount -r /dev/cdromdevicefile /mountpoint
where cdromdevicefile is the specific device file for the CD-ROM block device
(typically /dev/cdrom), and mountpoint is the mount point to use (typically /mnt).
Note: The filename in this command changes with each release of Red Hat
Linux. Before typing this command, list the files in the
/mnt/programs/linux/manager directory to verify the filename.
rpm --install /mnt/programs/linux/manager/RaidMan-4.70.i386.rpm
where mnt is the mount point of the device file used in step 3.
Note: For operating systems that automount the CD-ROM drive, you must first
close the window displaying the files on the CD.
umount /mnt
where mnt is the mount point of the device file used in step 3.
ServeRAID controllers.
d:
where d is the CD-ROM drive letter.
cd \programs\os2\manager\ship.os2
install
the program. On the final installation panel, be sure to specify the location
where you want to install the ServeRAID Manager program.
controllers when using OpenServer.
™
-4 Ultra160 SCSI Controller