IBM ServeRAID-4 Ultra160 Series User Reference page 76

2. After the operating system starts, insert the IBM ServeRAID Support CD into the
3. If you are using NetWare, go to step 5. If you are using Windows NT, Windows
4. Press Enter.
5. Copy IPSSEND to your hard disk drive by typing one of the following at the
For Windows 2000
For Windows NT
For NetWare
For OS/2
6. Press Enter. Remove the CD from the CD-ROM drive.
Installing IPSSEND for Windows 2000, Windows NT 4.0, or
NetWare from diskette
To install this program for Windows NT, Windows 2000, or NetWare from the IBM
ServeRAID Command-Line Programs diskette, do the following:
1. Start the server.
2. After the operating system starts, insert the IBM ServeRAID Command-Line
3. If you are using NetWare, go to step 5. If you are using Windows NT or
4. Press Enter.
5. Copy IPSSEND to your hard disk drive by typing one of the following at the
For Windows 2000
For Windows NT
For NetWare
58
®
IBM User's Reference: ServeRAID
CD-ROM drive.
2000, or OS/2, create an IPSADM directory on your hard disk. To do this, go to
the operating system command prompt and type:
md c:\ipsadm
where c is the drive letter of the drive where Windows NT, Windows 2000, or
OS/2 is installed.
command prompt:
copy z:\programs\winnt\cmdline\win2k\ipssend.exe c:\ipsadm
copy z:\programs\winnt\cmdline\nt4_0\ipssend.exe c:\ipsadm
Note: These instructions assume that you installed the following:
v NetWare in the NWSERVER directory
v The DOS CD-ROM device drivers.
copy z:\programs\netware\cmdline\ipssend.nlm c:\nwserver
copy z:\programs\os2\cmdline\ipssend.exe c:\ipsadm
Note: Where z is the drive letter for the CD-ROM drive that contains the IBM
ServeRAID Support CD and c is the drive letter where Windows NT,
Windows 2000, NetWare, or OS/2 is installed.
Programs diskette into the diskette drive.
Windows 2000, create an IPSADM directory on your hard disk. To do this, go to
the operating system command prompt and type:
md c:\ipsadm
where c is the drive letter of the drive where Windows NT or Windows 2000 is
installed.
command prompt:
copy z:\win2k\ipssend.exe c:\ipsadm
copy z:\nt\ipssend.exe c:\ipsadm
Note: These instructions assume that you installed NetWare in the
NWSERVER directory.
copy z:\netware\ipssend.nlm c:\nwserver
™
-4 Ultra160 SCSI Controller