IBM ServeRAID-4 Ultra160 Series User Reference page 160

ServeRAID ISPR, BCS, and ECS POST error codes
Notes:
1. When the ServeRAID controller requires your input, a list of function keys will
2. Where the Action information tells you to start the IBM ServeRAID configuration
3. Where sid or ch appears in these messages, sid is the SCSI ID for the device,
4. Where m or n appears in these messages, a number will appear in the actual
ISPR (Interrupt Status Port Register) codes
Basic and Extended Configuration Status Register Codes
BCS ECS Explanation
Code Code The ServeRAID controller is not functioning
not in not in properly.
table table
00 01 Invalid flash configuration.
00 02 Invalid NVRAM configuration.
00 03 Invalid flash and NVRAM configuration.
142
®
IBM User's Reference: ServeRAID
appear below the message.
program, insert the IBM ServeRAID Support CD into the CD-ROM drive; then,
restart the server. The Action column also provides general information about
the message.
and ch is the channel to which the device is attached.
message.
Code Explanation
1xxx to The POST detected an internal error.
7xxx
2601 to The POST detected an error with the
260B ServeRAID subsystem.
2610 The POST detected an error with the
ServeRAID controller hardware.
2620 The POST detected that a ServeRAID
configuration or hard disk error
occurred.
8xxx to The POST detected an error with the
Bxxx SCSI interface.
™
-4 Ultra160 SCSI Controller
Action
Have the server serviced.
Have the server serviced.
Have the server serviced.
Start the IBM ServeRAID Support CD
and view the existing device and
configuration information for your
ServeRAID subsystem. If you cannot
locate and correct the configuration
problem or the failing device, or if the
problem persists, have the server
serviced.
Verify that the SCSI cables are correctly
connected and the SCSI termination is
set properly for each installed SCSI
device.
If you cannot locate and correct the
SCSI problem, or if the problem
persists, have the server serviced.
Action
Have the server serviced.
Start the IBM ServeRAID Support CD and follow
the instructions that appear on the screen.
If no instructions appear or if the problem persists,
have the server serviced.