IBM ServeRAID-4 Ultra160 Series User Reference page 56

Figure 15. Configuration summary window
16. Click Apply to accept and save the configuration. The configuration is saved in
17. If you have multiple controllers, for each controller repeat steps 1 on page 34
18. When you have completed configuration, you can change to Information mode
19. Restart the server.
20. Continue with "Chapter 5. Installing ServeRAID device drivers" on page 41 to
38
®
IBM User's Reference: ServeRAID
Note: To change the configuration, click Modify arrays or Modify logical
drives.
the ServeRAID controller and on the physical drives.
through step 16.
and change controller settings. See "Using Information mode" on page 39 for
more information. If you do not want to change any settings, exit the
ServeRAID Manager program and remove the CD from the CD-ROM drive.
install the ServeRAID device driver while installing your operating system.
Note: If you are configuring your startup (boot) ServeRAID controller, you
must install the device driver while installing the operating system.
™
-4 Ultra160 SCSI Controller