Start Obelisk Program - Theben SELEKTA top2 Series Manual

CHECK OBELISK
continue with button ►
END
If the OBELISK top2 is disconnected again whilst the OBELISK menu is displayed, the OBELISK
menu is exited and, after displaying "ABORT" briefly, the system returns to auto mode.
Exception If the OBELISK top2 is disconnected after confirmation of the END menu, ABORT is not
displayed.

Notes:
o
When the OBELISK top2 is inserted, only both right-hand buttons ► and the OK
button are available, since both left-hand buttons "Menu" and ◄ are difficult to
operate.
o
An inserted OBELISK top2 is not detected if the time switch is reset  needs to be
removed and re-inserted.
o
If the time switch is locked by a PIN, an inserted OBELISK top2 is ignored.
o
If no button is pressed in the OBELISK menu for the duration of the automatic return,
the system changes to auto mode. If a button is pressed again, the OBELISK menu is
displayed again, provided the OBELISK top2 is still inserted.
o
When copying, the text COPY is shown for the duration of the copying procedure,
along with a progress bar on the time switch display. If the OBELISK top2 is
disconnected during this time, incomplete or erroneous program data is stored.
o
The power reserve is reduced when OBELISK top2 is inserted (in battery mode).
Note: If nothing is saved on the OBELISK top2 (i.e. it is empty) and the menu item COPY OBELISK 
TIME SWITCH is selected, an "empty program" is written to the time switch. The switching times in the
time switch are deleted.

12.4. Start OBELISK PROGRAM

Insert the OBELISK top2. After verification of the date, the OBELISK menu appears.
Continue with button ► until START OBELISK PROGRAM appears.
Press OK to confirm.
The system switches to auto mode, however, OBELISK is displayed in the time switch
text line and the program saved in the OBELISK top2 is active.
Page | 78