13.5.11 Sending location data to the time switch
You can use this function to send current geolocation data to the device. The location data is
determined automatically via the smartphone/tablet GPS function or can be entered manually via
longitude/latitude degrees.
Latitude
Longitude
13.5.12 Executing a manual switch command
You can use this function to switch the channels of the time switch manually (irrespective of the
programmed switching times).
The following options are available:
Manual switching/switching preselection
Permanent ON
Permanent OFF
13.5.13 Manual switching/Switching preselection
The channel status (ON/OFF) is reversed. The programmed switching program remains active in the
time switch and is executed automatically again on the next switch command.
+/- 90°
+/- 180°
Page | 91