Menu: Program; Program Menu: Standard (Night Break/Daytime Switch-On); Standard: Setting A Switching Time - Theben SELEKTA top2 Series Manual

8. Menu: PROGRAM

Press the MENU button to open the main menu from auto mode:
Sub-menu: PROGRAM
STANDARD – SPECIAL 1 – SPECIAL 2 – SPECIAL 3 – TOTAL – DELETE ALL – END
ASTRO PROG

On the SELEKTA 170 top2/top3 devices, only STANDARD switching times can be
programmed in addition to astro times.

In the SELEKTA 171 top2/top3 RC and SELEKTA 172 top2/top3 devices, the switch
commands for the special programs are available too. After selecting PROGRAM, the
selection menu for the type of switch command STANDARD, SPECIAL1 ASTRO, SPECIAL2
ON, SPECIAL3 OFF is available.
8.1.

PROGRAM menu: Standard (night break/daytime switch-on)

Switching times can also be programmed outside or inside the astro times. In the standard program,
this is achieved via NIGHT BREAK or DAYTIME SWITCH-ON.

8.1.1. STANDARD: Setting a switching time

Programming example
The lighting for a shop window featuring exhibits is switched ON in the evening and OFF in the
morning according to the astro times. The time switch is to be used to program a night break as well,
i.e. the lighting for the shop window should not be on the entire night, but should be switched off
between 11:00 PM and 5:00 AM, Monday to Friday (this is known as a night break).
Press the MENU button to open the main menu from auto mode.
Press button ► once until PROGRAM appears on the display and press OK to confirm
the PROGRAM menu.
ON OFF SIMULATION
Page | 27