Advertisement
L Presetting: all connected sensors are active for all chan-
nels. The sensor that sends the lowest lux value is active
Activating PIN code
The PIN code is set in OPTIONS via the menu.
L If you have forgotten your PIN, call the Theben Hotline.
L Have the serial number ready.
MENU
OPTIONS
SENSORS
OPERATING
HOUR
LCD-
ILLUMINATION
LANGUAGE
PIN
u
NO PIN
FACTORY
WITH PIN
SETTING
INFO
END
Setting manual or permanent switching
Manual or permanent switching can be set via the menu in
MANUAL or (in the automatic screen) by button combination
(see picture).
•
Manual control:
Reversing the channel status to the next automatic or
programmed switching.
•
Permanent switching:
As long as a permanent switching (on or off) is acti-
vated, the programmed switching times and switching
thresholds are ineffective
Channel
C1
Activating manual control
Briefly press both buttons simultaneously
†
¾
Activating permanent switching
Press both buttons simultaneously for 2 seconds
†
¾
Cancelling manual/permanent switching
Press both buttons simultaneously
†
¾
Set external input (only LUNA 111 top3)
For the channel, an EXTERNAL INPUT (see figure) can be set
with different functions.
3 sub-menus can be selected: Inactive, push button (function),
switch (function)
•
NOT ACTIVE: The external input has no function
u
CURRENT PIN
NEW PIN
00 00
ok
Channel
C2
•
BUTTON: Manual (manual control), Timer (countdown
timer) are selectable
•
SWITCH: Permanent On, permanent Off are selectable
L If a function is activated via an external push button or
switch, EXTERNAL is displayed.
MENU
u
OPTIONS
SENSORS
OPERATING
HOUR
u
EXT INPUT
LCD-
ILLUMINATION
u
u
RESETABLE
MINUTES
EARLY CUT
Press MENU, with u select EXT INPUT and follow the indi-
†
¾
cations on the display.
L Additional power unit required for GPS if only one device
is connected to the antenna.
L Refer to the operating instructions when connecting a GPS
antenna (9070610).
Minimum number of participants needed to operate the GPS
antenna:
•
2 x weekly timer TR 611 top3 RC, SELEKTA 171 top3 RC
LUNA 121–122 top3 RC each with 50 mA feed, or
•
1 x weekly timer with 50 mA feed plus 1 x top2 GPS
power unit (9070892) with 50 mA feed
Hour counter
The operating hours of the channel (relay) are displayed and
deleted in the OPTIONS menu. If the number of operating
hours exceeds the value set in the Service menu, SERVICE will
appear in the display.
Example: Replace a lamp after after 5,000 h.
Delete operating hours or set a higher value in Service (e.g.
†
¾
to 10,000 h)
Using Bluetooth OBELISK top3
All functions can also be transferred to the twilight switch
using the Bluetooth OBELISK top3 memory card (9070130).
*
Use switch without glow lamp (e.g.
in stairwells)
*
u
u
BUTTON
STAIRCASE
LIGHT
SWITCH
OVERRIDE
NOT ACTIVE
TIMER
4
Advertisement
