Using The Remote Controller; For Best Results; Addresses - Panasonic S-160PE1R5B Technical Data & Service Manual

8-26. Using the Remote Controller

Point the transmitter of the remote controller at the receiver. When the signal is received correctly it will beep once.
(It beeps twice only when the unit starts operating.)
The signal can be received at a distance of about 6 meters. This distance should be used only as a guide.
It depends on battery strength.
Make sure nothing is between the remote controller and the receiver that could block the signal.
Do not leave the remote controller in direct sunlight, where the wind from the air conditioner can blow directly on it, or near
any other heat source.
Take care not to drop, throw or wash the remote controller with water.
The signal from the remote controller may not be received in rooms with rapid start fluorescent lighting, inverter lights, plasma
displays, LCD televisions (monitor), etc. For more information, please contact the dealer where the product was purchased.
Wall Mount Use
• Press from the location you wish to mount the remote controller
and make sure the signal is received properly.
• Pull the remote controller forward to remove it.

8-27. For Best Results

Don't get the remote controller too far away from the receiver.
This may cause a malfunction. Be sure to keep the remote controller in the same room as the receiver.
Point the remote controller at the receiver.
When the signal is received properly, it will beep one time.
Avoid locating the remote controller where it is covered, such as behind a curtain.
Keep it out in the open.

8-28. Addresses

In both multi and single unit installations, when more than one indoor units are installed in the same room with a
compatible wireless remote controller, addresses can be set up to avoid crosstalk. By setting the address switches on the
receivers and matching them with the number of addresses on the remote controller, up to six indoor units can be controlled
separately with the remote controller. (When using units in a flexible combination or operating multiple units simultaneously,
they cannot be controlled individually as they are operated at the same time.) There are separate address settings, receiver
addresses for the receivers and transmitter addresses for the remote controller.
For more information, please contact the distributor where the product was purchased.
• These settings are saved in nonvolatile memory in the remote controller, so even when its batteries are changed, the settings
do not have to be made again.
8
Checking Addresses
When you press
address of a receiver , the buzzer sounds. (If it is on ALL, the buzzer will always sound.)
If it is on ALL, it can be operated regardless of receiver addresses. Point the remote controller at the receiver you wish to
operate and transmit.
on the remote controller, its current address appears on the display. If this address corresponds to the
Fasten the remote controller
holder with screws.
Remote controller holder
8-22
Fitting the remote controller
in the holder.
2
Press
1
Put in