Optional Controller (Remote Controller); Names And Functions - Panasonic S-160PE1R5B Technical Data & Service Manual

2. Wireless Remote Controller

Optional Controller (Remote Controller)

Wireless Remote Controller CZ-RWSC3 / CZ-RWSK2
One remote controller can control a group of up to eight indoor units.

8-19. Names and Functions

REMOTE CONTROLLER
1. Operation Display
2. Start/Stop
button
3. Fan speed
button
4. Swing/Wind
Direction button
5. Timer setting
button
6. Reset button
7. Cover
8. Transmitter
9. Remote controller
sensor
10. Temperature
setting buttons
11. Filter button
12. Mode Select
button
13. Ventilation
8
button
14. Address
button
Displays the operation status.
(The figure shows all the statuses.)
The auto-flap display may be different,
depending on the installed unit.
Pressing this button once starts and
pressing again stops the operation.
Use for operating with a timer.
Use this button after changing the
batteries.
Press at the top center and then
slide down.
Detects the temperature at the
remote controller when detection
has been switched to the remote
controller by the sensor button.
raises the temperature setting
1 at a time.
lowers the temperature setting
1 at a time.
CZ-RWSC3
Press to turn off the filter lamp on
the receiver.
Press to switch the operation mode.
Use this button when connected to
an aftermarket fan. Pressing this
button starts and stops the fan.
When the air conditioner is started
or stopped, the fan starts or stops at
the same time. ( appears on the
display of the remote controller
when the fanis operating.)
15. Sensor button
16. Clock button
1
2
3
4
5
6
7
From this page on the names of remote controller's
buttons will be indicated with the above illustrations.
E.g.: Start/Stop button
8-16
Use this button to activate the
temperature sensor on the remote
controller instead of the one on the
indoor unit. The temperature sensor
on the indoor unit is selected before
shipment. At this time is shown
on the display.
Use this button to set the clock.
8
9
10
11
12
13
14
15
16